Innotech MAXIM 1010, Руководство по установке

Страница: 54 / 60

MAXIM Installation Instructions
Page 54 © Mass Electronics Pty Ltd 2011 Edition 2.0 dated 20/11/2013
A-1 Overview
The Commissioning Tool – Subsystem Network (CT01) is a Human Machine Interface (HMI) that
allows you to configure controllers on a Subsystem network. It provides full access and navigation
through the menu structure of the Subsystem controllers. You can use the CT01 to commission
the controllers as an alternative to the software method. The CT01 can interface directly with the
following controllers:
• VAVMax (VM01)
• MiniMAX (MM02)
• MicroMAX (UM01)
It can also interface directly with the Subsystem Network using the provided adapter cable. Once
connected to a Subsystem network, the CT01 can be used to search, log onto, and access any
particular controller on that network.
The steps involved in commissioning your controllers using the CT01 are listed below:
• Connecting to the Sub System Network device.
• Logging onto the controller
• Configuring settings on a controller
• Commissioning the controller (Checking Max/Min airflows, Heater Bank testing & Temperature
Calibration)
A-2 Connecting to Subsystem Network Devices
There are three options when connecting the CT01 to the Sub System network, and each is described
and illustrated in the following sections.
A-2.1 Connecting directly to controller on sub system network
If you connect the CT01 directly to a controller on the sub system network, such as a VAVMax, you will
only be able to communicate to that particular controller. You will not be able to connect to other
controllers on the same network, as illustrated in Figure A-1.
Figure A-1:
Connecting the CT01 to a Sub System Network Device