10
BARRIER-ATTIKA/190611/www.innotech.at
EN
6.1
INSPECT BEFORE EVERY USE
6
INSPECTION
Refer to the test log for inspection intervals.
If there are any doubts concerning the safe use of the safety
system, it must NOT be used any more, and must be checked by an
expert (written documentation). If necessary, the product must be
replaced.
6.2
INSPECT REGULARLY
INNOTECH “BARRIER” is maintenance-free. Every 2 years, the system must be
inspected by an expert, familiar with the safety system. The user's safety depends on
the effectiveness and durability of the equipment.
Shorter inspection intervals may be required, depending on the intensity of use and the
environment (e.g. in corrosive atmospheres, etc.).
Document the inspection by the specialist/competent expert in the test log
of the instruction manual, and keep this with the instruction manual.
DANGER TO LIFE through damage to the INNOTECH "BARRIER".
-
INNOTECH "BARRIER" must be in perfect working condition.
-
Do NOT continue to use INNOTECH "BARRIER" if
•
There is obvious damage or wear to its components,
• Other defects were observed (loose threaded joints, deformation,
corrosion, wear, etc.),
•
Strain has occurred due to a fall against or into the side protection
system,
•
It is not possible to read the product labelling.
!
DANGER
Prior to each use, INNOTECH "BARRIER" must be inspected visually for any obvious
defects.
Check the entire safety system's suitability for use on the basis of the acceptance log
and test log.
