To attach gaskets to mounting plate (outdoor installations only):
Figure 4:
Mounting Plate with Outdoor Gaskets
1. Insert the perimeter gasket to the front of the mounting plate and attach
the wall gasket to the rear of the mounting plate (both gaskets supplied
loose in the Outdoor Install Kit). See
Figure 4
on
Page 6
.
To secure the mounting plate to a support:
Figure 2
on
Page 4
shows the dimensions of the mounting plate (matches
the back plate of the reader).
■ With the mounting plate facing forward, attach the mounting plate to a
wall or other support by inserting two or four screws (not supplied) into
the mounting plate holes (see
Figure 5
on
Page 6
). The type of screws
depends on the type of support used.
Figure 5:
Mounting Reader to a Support
■ For mounting outdoors, the wall plate will
most likely be attached to a brick wall.
Suitable screws and wall anchors (not
supplied) would be:
• No. 6 (3.5mm) x 1" long minimum
PHIL CSK Tapping Screw A2 Stainless
Steel:
Figure 6:
Screws for attaching reader to brick wall
Gauge/Metric: #6 (3.5)
dk: 6.80-6.44; k (max): 2.10; d (drive): #2
■ For mounting indoors, wall anchors (not supplied) that can be used
include:
• 2880-0083-02 ANCH PL W/O SCR 7/8L #6 #8 #10
• 2880-0073-00 Butterfly Wall Plug for #6 Screw (for hollow/dry wall)
6
Innometriks Cheetah SE Reader Quick Start Guide
