SkyGuard Interactive Gateway Module. Rev.1.4. May. 2017
16
Troubleshooting
If the “CS or “Platform” LEDs are blinking, here are possible problems:
•
Incorrect wiring.
•
Incorrect panel switch position.
•
Unsupported panel version.
•
Unsupported panel model.
•
Panel is in Installer Program Mode.
Vista Specific:
•
AUI not enabled.
•
AUI used for some other function.
•
LRR not enabled.
•
Another LRR or IP/GSM device connected to panel bus.
Concord Specific:
•
Module not enrolled into the Concord Bus (perform another bus scan)
•
Another Automation device is enrolled on the Concord Bus.
Factory Default Button
This button has two functions:
•
Holding this button for approximately 5 seconds will reset the RE927X Communicator.
•
Holding this button for approximately 10 seconds (LEDs will flash off twice) will set the RE927X to
factory defaults.
Links
CSD Support
http://www.centralsd.com.au/Support.aspx
Inner Range homepage
http://www.innerrange.com/
Inner Range Training & Support
http://www.innerrange.com/Training-Support
Skycommand
https://skycommand.innerrange.com/skycommand/
Skyguard
http://sguard.com.au/skyguard/
Notices
“Paradox“, “Magellan”, “GE”, “Honeywell”, “Vista”, and “DSC” are trademarks owned by Paradox Security
Systems Ltd., General Electric Company, Honeywell International Inc. and Tyco Safety Products Canada
Ltd, respectively.
SkyGuard (Inner Range P/No: SG-RE927X) is manufactured for Inner Range Pty. Ltd. by Resolution
Products, Inc. This product will function with one of either Paradox, GE, Honeywell or DSC systems.
However, the product is not produced by, endorsed by, nor is officially associated with Paradox, GE,
Honeywell or DSC. Inner Range recommends verifying proper enrollment and operation, per control panel
installation instructions, at installation.
Disclaimer
:
1. The manufacturer and/or its agents take no responsibility for any damage, financial loss or injury
caused to any equipment, property or persons resulting from the correct or incorrect use of the
system or it’s peripherals. The purchaser assumes all responsibility in the use of the system and its
peripherals.
2. While every effort has been made to ensure the accuracy of this manual, the manufacturer assumes
no responsibility or liability for any errors or omissions. Due to ongoing development, product
specifications and the contents of this manual are subject to change without notice.
www.innerrange.com
Ph: +61 3 9780 4300
© 2016 - 2017. Inner Range Pty Ltd.
Document P/No: 63RE927X
