SkyGuard Interactive Gateway Module. Rev.1.4. May. 2017
13
Caddx NX Programming and Connections
Compatible with all NX series panels.
Account Setup
10) Refer to IGM account
setup
instructions on page 2 and set up the
account on the Dealer Portal.
11) Be sure to add a contact that uses
the system MASTER CODE to the
account before connecting the
module. This will ensure the
module can properly
communicate with and configure
required system settings.
Panel Programming
12) None Required
IGM Connection
13) Disarm the system (all partitions).
14) Power down the NX system.
15) Set the RE927X panel selector switch to CDX.
16) Connect the NX panel and the RE927X as shown in the Wiring Instructions above.
17) Apply power to the NX system. During this process, the communicator will program the following
settings:
•
Enable Opening and Closing report.
•
Set Telephone Line Cut delay to 0 (no TLM).
18) Installation complete.
Important: Do not attempt to enter program mode until the CS and Platform LEDs have stopped flashing.
Additional Notes for NX installations:
•
Some NX panels limit the number of non-keypad devices they support. Be sure that the panel
you are connecting the communicator to does not have more than the number of support
devices connected.
•
User codes that are added to the system or edited through the communicator will have the
default or previous partitions enabled. If you desire the users to have different partitions enabled,
you will need to modify the partitions thru the NX keypad.
•
6-digit access codes are not supported.
