Inner Range CONCEPT IQ, Руководство пользователя

Страница: 23 / 28

23
Version 1.03 January-2002
5. Telephone Remote Control
Consult your installer to ascertain whether your system has Telephone Remote Control enabled.
(Telephone Remote Control requires the DTMF Card to be fitted to the Control Module)
TELEPHONE KEY FUNCTIONS:
The following Telephone Keys are used to perform the specified LED Terminal functions:
IMPORTANT NOTE: Use short key presses. If keys are held down they may register as multiple presses.
<*>
Arm / On
<#> Disarm / Off
<9> NEXT
OPERATION:
Call the system and Logon: System Telephone Number: .....................................................
1) Dial the telephone number of the system from a Touch-tone (DTMF) telephone or mobile phone.
2) When the Control Module answers you will hear a brief tone.
3) When the line is quiet, enter your PIN Code on the telephone keypad.
4.1) To Arm or Disarm the System:
To Arm:
-All Areas in your Area List. Press <*>
-A specific Area. Press <Area Number>, <*>
To Disarm: -All Areas in your Area List. Press <#>
-A specific Area. Press <Area Number>, <#>
e.g. To Arm Area 2. Press: 2, <*>.
The Control Module will then reply with a Status message:
- A series of Beeps of the same tone to indicate the operation was successful.
- A series of Beeps of 2 different tones to indicate the operation could not be performed.
IMPORTANT NOTE:
You MUST wait to here the Status message beeps before attempting another command.
4.2) To Control an Auxiliary Output:
a) Select Auxiliary Control Mode: Press <9>, then 24 (Auxiliary Control & Test Mode)
b) Turn an Auxiliary On: Press <Auxiliary Number>, <*>
Turn an Auxiliary Off: Press <Auxiliary Number>, <#>
e.g. To Turn Auxiliary 3 Off. Press: 3, <#>.
c) Logout of Aux Control Mode: Press <#>. (If this is not done before hanging up, you must wait
at least 30 seconds before calling the system again)
No Status message beeps are sent for Auxiliary control operations.
DIAL-UP CONTROL