Press the air temperature sensor in to the 1525 sensor grommet (A). Insert the
air temperature sensor into the grommet until it bottoms out (B).
Here, the air temperature sensor, CCV hose, CCV box, and breather lines have
been installed and completed.
Take the 1 1/8” ID CCV hose, place two mini-clamps on each
end of the CCV hose as shown above (A). Press the CCV hose
over the large intake port as shown above.
Once the CCV box has been correctly installed
continue to tighten the mini-clamp.
>>>>
>>>>
Once the CCV hose has been positioned
correctly, continue to tighten the lower clamp(A).
Now press the CCV box over and into the CCV
hose as shown above (B).
>>>>
>>>>
(A)
(A)
(B)
(B)
(A)
(A)
(B)
(B)
(A)
(A)
(B)
(B)
For cold air intake installation- Place the 3” hose over the end of the intake and
use two Power-bands, tighten the clamp on the intake side for now (A). Take the
male/female m6 vibra-mount and screw it into the fender wall pre-tapped hole as
shown above (B).
The screw is tightened into the bumper frame and the
horn is now relocated.
For short ram installation- Take the Injen filter and press it over the end of the
intake (A). Once the filter has been properly installed continue to tighten the
filter neck clamp (B).
The stock horn is removed from its stock location
and is turned around to keep intake from rattling.
Turn the horn around so that it faces outward.
Position the horn in place and screw the bolt back
into the bumper frame.
(A)
(A)
(B)
(B)
(A)
(A)
>>>>
>>>>
(B)
(B)
>>>>
>>>>
>>>>
>>>>
Stock horn position
Stock horn position
Stock horn is flipped
Stock horn is flipped
Stock horn is in new position
Stock horn is in new position
