Removing the resonator flex-hose: Pop the
first plastic clip on the side frame. The clip
attaches the flex-hose bracket to the frame.
A screwdriver is used to pop and remove the plastic clip (A).
The head on the plastic clip has been lifted and the clip is now
removed (B).
Removing the m6 bolt from the air intake resonator
bracket.
The secondary intake is inserted into the primary
intake hose as shown above.
The m6 flange nut and fender washer is used to fas-
ten the secondary intake to the vibra-mount stud.
Once the plastic clip and m6 bolt have been
removed, continue to pull the air intake flex-hose from
the front bumper.
The lower or filter end of the secondary intake brack-
et is aligned to the secondary vibra-mount stud.
The filter is now aligned to the end of the secondary
intake.
The filter is firmly pressed over the end of the intake.
The end of the intake will press up against the filter
stop. Tighten the filter clamp once the filter has been
pressed up against the intake end.
The secondary intake bracket is aligned to the vibra-
mount stud.
Lower the secondary intake into the bumper area
while aligning the top end with the primary intake.
Figure 44
Figure 43
Figure 42
Figure 41
Figure 40
Figure 48
Figure 49
Figure 50
Figure 47
Figure 46
Figure 45
Page 5 of Part# SP2106
>>>
>>>
>>>
>>>
>>>
(A)
(B)
Figure 39
The ground cable has been relocated to the air box
bracket position and the negative battery terminal is
facing the towards the firewall for better clearance
of the secondary intake.
>>>
>>>
