Loosen and remove the three m6 bolts holding the
lower air box to the lower brace.
Once the three bolts have been removed, continue to
remove the lower air box cleaner from the engine
compartment.
Depress the hose clamp located on the air duct that is
connected to the throttle body.
Once the air box top has been removed, continue to
remove the white filter panel from the lower air box.
Disconnect the electrical sensor harness from the
mass air flow sensor.
Once both screws have been removed, continue to
pull the mass air flow sensor from the sensor
housing.
Stock box shown in this picture
Loosen the hose clamp that secures the air duct to
the mass air flow sensor.
The crankcase breather hose is disconnected from
the air duct port
Unscrew and remove the two screws that fastens the
mass air flow sensor to the sensor housing.
Unlatch the two metal clamps shown above and
remove the air box top.
Use a 10mm socket to remove the m6 bolts from the
air box cleaner.
Figure 3
Figure 4
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10
Figure 11
Figure 12
Figure 13
Figure 14
Page 2 of Part# SP2106
>>>
>>>
>>>
>>>
>>>
>>>
