INIM Electronics SmartLink Advanced, Инструкция по установке и программированию

Страница: 15 / 36

SmartLink functions 15
Installation and programming manual
3-6-1
Commands over the GSM
network
Up to 200 actions can be programmed to activate in response to
remote GSM commands.
Each of the actions can be triggered by either an SMS command or a
Caller ID command or both.
COMMAND VIA SMS
MESSAGE Users who wish to activate a command via SMS text must enter the
command details as follows:
<xxxxxx> <SMS Text>
where:
•
<xxxxxx> stands for the user PIN
• a blank space must be keyed in after PIN entry
• <SMS text> is the identification of the command, as
programmed via software
DEFAULT COMMANDS Three commands are predefined at default:
•
“ CREDIT ” for balance enquiries relating to the SIM card of the
device; the user will receive an SMS text indicating the
remaining credit.
• “ STATUS ” for enquiries relating to the status of the SmartLink;
the user will receive an SMS text indicating:
•• device name and firmware revision
•• GSM network provider
•• GSM signal reception level
•• Presence of the PSTN line
•• list of faults present
•• device tamper status
•• power supply of the circuit
•• armed/disarmed status of the SmartLink
•• list of zones in alarm status
•• list of terminals in tamper status
•• status of outputs
•• remaining credit as last read
• “ CONNECT ” for the maintenance request; the message text
format must be:
<xxxxxx> CONNECT <Connection Name> <URL>:<Port>
where:
•• <xxxxxx> is the installer code PIN, followed by a blank space
•• “CONNECT” is the connection command, followed by a space
•• <Connection Name> is the description of the connection
followed by a space
•• <URL>: is the IP address of the server you wish to connect
to, followed by “:”
•• <Port> is the connection port
the latter two parameters can be omitted if they have already
been included in the GPRS section programming fields of the
SmartLink.
INCOMING CALLER ID
COMMANDS A Caller ID command is a command requested over-the-phone by
an end-user whose telephone number is present in the configuration
of the actions to be carried out following the command. This type of
telephone number must be associated with a user code.