INIM Electronics SmartLink Advanced, Инструкция по установке и программированию

Страница: 16 / 36

16 SmartLink functions
Telephone dialler
The SmartLink recognizes the Caller ID and activates the
programmed actions.
Note
The remaining credit control feature is subject to temporary or even
permanent unavailability caused by changes in the implementation of the
methods used by the GSM/GPRS service provider.
INIM provides device programming functions which may be capable of
restoring this feature, by means of manual changes to the respective
parameter settings.
3-6-2
Answerphone
The “answerphone” function, if enabled by the installer on the PSTN
or GSM network line, allows the SmartLink to answer incoming
phone calls. Following is the procedure which activates the
programmed action:
1. Call the number of the SIM Card inserted in the SmartLink or
the telephone number of the PSTN line connected to the
device.
2. After a programmed number of rings, the SmartLink will
engage the line and play the voice message:
Type-in code followed by “#”
3. Enter a valid user-code then press “#” on the telephone
keypad.
4. The SmartLink will start a voice message listing the shortcuts
associated with the entered code and the corresponding keys
on the telephone keypad (voice menu).
5. Activate the required commands by pressing the correspon-
ding keys on the telephone keypad.
3-7
Easyscan
The “Easyscan” function of the SmartLink allows the installer to
select the best GSM network provider for the SmartLink installation,
in accordance with the signal reception.
This function can be activated exclusively via the SmartLeague
software programme and does not require the presence of a SIM
card in the SmartLink.
Once initialized, the SmartLink scans the GSM signals available in
the installation zone. When the scan is complete the software will
show a list of the operators detected in the area and the reception
quality of their signals. This data can be used by the installer to
optimize the installation.
3-8
Jamming detector
The jamming detector allows the SmartLink to check for intentional
or unintentional wireless interference and, if necessary, generate a
“Jamming” event when the source disrupts wireless transmission
and inhibits the GSM network signal.