Ingeteam INGEREV RAPID 120, Инструкция по установке и эксплуатации

Страница: 70 / 248

ACA2011IQM01_ - Installation and Operation Manual
6. Installing the unit
Before installing the unit, the packaging must be removed, taking special care not to damage the housing (see
section
“3.1. Unpacking” ).
Check that there is no condensation inside the packaging. If there are signs of condensation, the unit must not be
installed until you are sure it is completely dry.
CAUTION
All installation operations must comply with current regulations.
All operations involving moving heavy weights must be carried out using the required mechanical means (crane,
hoist, etc.).
6.1. General requirements for installation
• The environment of the unit must be appropriate and meet the guidelines described in chapter “5.
Preparation for installing the unit” . Additionally, the parts used in the rest of the installation must be
compatible with the unit and comply with the applicable legislation.
• The ventilation and workspace must be suitable for maintenance tasks according to the applicable
regulations in force.
• The external connection devices, which must be suitable and sufficiently close as set forth in current
regulations.
• The feed cables must be of the appropriate gage for the maximum current.
• Special care must be taken to ensure that there are no external elements near the air inlets and outlets
that obstruct proper cooling of the unit, respecting the distances indicated in section
“5.1. Environment” .
6.2. Fastening the unit
The fixing points are designed for the use of threaded rods or M12 screws. If using a threaded rod, its length above
the ground must be 20 to 30 mm.
332
16
379
Distances between the ground fixing points, top view
70
Installing the unit Ingeteam