Ingersoll-Rand VHP40RMD, Руководство по эксплуатации и техническому обслуживанию

Страница: 43 / 55

Maintenance/Lubrication Operation & Maintenance Manual
23221138 (12-07) Rev A 39
Oil Consumption
It is normal for compressor pumps to consume some oil. A rule of thumb for compressors in
this horsepower class is consumption of approximately one fl.oz. oil per 5 hours of operation.
The difference between the low oil level (mid-sight glass) and full (oil at top of sight glass) is
about 16 fl.oz.
Operation for extended periods of time at low discharge pressure will increase oil
consumption.
Oil consumption for new or rebuilt pumps will be higher during the first 100 hours of operation
as the piston rings seat. After that time the consumption should stabilize.
Do not operate the compressor with low or no oil. Severe damage to the pump will result. Note:
It is NOT possible to accurately read oil level while compressor is running.
Oil Change Procedure
NOTE: Note: Pump refill capacity is 50 fl.oz. (1.5 L.)
1. Oil drain will be faster and more thorough if done after oil is warmed by
operating compressor.
2. Remove the oil drain plug and allow the oil to drain into a suitable container.
CAUTION
!
Do not remove the oil filler plug while the compressor is running.
3. Replace the oil drain plug. Hand tighten only.
4. Re-fill compressor with oil to near top of sight glass.
5. Dispose of used oil in responsible manner.
CAUTION
!
Do not operate without lubricant or with inadequate lubricant. Ingersoll
Rand is not responsible for compressor failure caused by inadequate
lubrication.
We recommend ALL Season Select synthetic compressor lubricant. Units are factory filled
with this oil.
You may use a petroleum-based lubricant that is premium quality, does not contain
detergents, contains only anti-rust, anti-oxidation, and anti-foam agents as additives, has a
flashpoint of 440° F(227° C) or higher, and has an auto-ignition point of 650° F(343° C) or
higher.