Ingersoll-Rand TRANE AFDJ, Инструкция по установке, эксплуатации и обслуживанию

Страница: 30 / 66

Pre-Installation
30 AFDJ-SVU01D-EN
Note: The lift points on the drive may not be equidistant
from the center of gravity.
4. Select or adjust the rigging lengths to compensate for
the weight distribution of the load. Maintain the
equipment in an upright position.
5. To minimize risk, the drive should only be lifted high
enough to clear obstacles. There will be some tilt due
to uneven weight distribution within the drive.
Removal of Lifting Angles
Lifting angles should be removed only when the drive is in
its final location. The lifting angles are retained with
hardware. These hardware bolts need to be reinstalled in
their holes in the top of the drive to prevent the ingress of
foreign matter into the enclosure (see
Figure 22 ).
Drive mounting instructions are provided in the Rockwell
literature that shipped with the drive.
Storage
Important: Store the drive in the following conditions if
the equipment will not be installed
immediately after receiving it:
• Store the drive in a clean, dry, dust-free environment.
• Storage temperature should be maintained between
-4°F to 149°F (-20°C to 65°C). Occasionally, liquid-
cooled drives are provided with coolant that has a
freezing point higher than -4°F (-20°C). Check the freeze
point of the coolant by reading the label on coolant
drum and ensure that the storage temperature does
not go below that point. Relative humidity must not
exceed 95 percent, non-condensing. It is
recommended that the equipment be stored in a
heated/climate-controlled building with regulated air
circulation to avoid damage.
Notes:
– Remove all packaging from the drive while storing
it to prevent condensation from damaging the
equipment. However, keep the drive covered
Figure 21. Overhead lifting
WARNING
Do Not Tilt Drive!
Tilting the drive could cause heavy items to shift, which
could result in death, personal injury or equipment
damage. Do not tilt the drive! Drive must remain
vertical. Drives may contain heavy components that are
mounted for vertical support.
45.0° Max
Figure 22. Insert bolts
WARNING
Drive Mounting Instructions!
Failure to correctly anchor the cabinet could result in
death or serious injury and equipment damage. Refer
to Rockwell’s technical drawings and installation
manual for drive mounting instructions. Contact the
area Rockwell Automation sales office if you do not
have these documents.
NOTICE:
Equipment Damage!
Failure to follow storage recommendations could result
in equipment-only damage. Read this section carefully
and follow all recommendations for drive storage.