10
18-GJ06D2-2E-EN
5.
Remove airflow diverter from the bottom of coil drain pan by
gripping the plastic diverter while using your thumbs to spread
the top of the diverter slightly outwards and then pulling down
and out through the blower opening as illustrated.
6.
Disconnect wires to the EEV motor and sensors. Cut the wire ties on
those wire harnesses if necessary and replace after re-installing.
Note:
If cut, wire ties that held the sensor must be replaced after the coil is
placed back into the cabinet.
7.
Slide Coil assembly out of unit using built-in coil support channels
and set aside
Co il S u p p o rt
Ch a n n e l
O
Op
pttiio
on
na
all C
Ca
ab
biin
ne
ett D
Diissa
as
ss
se
em
mb
blly
y
