Ingersoll-Rand R132, Информация о продукте

Страница: 17 / 48

EN-17 80446339 Rev B
EN
The bottom of the screen is divided into thirds with the words in each small
box showing the function of the button directly beneath it. The words will
change in these boxes depending on what actions are permitted at any
particular time. The action resulting from pressing each of these buttons is
indicated in the Operator Panel Flow Diagram later in this section. This can
be used as a quick reference of how to step the controller screen through any
desired function.
Current status
Figure 15: Current Status Screen
The CURRENT STATUS screen is considered to be the “normal” display that the
controller shows.
The following items and their present values can be displayed on the right
side of the screen by pressing the up and down arrow buttons.

CURRENT STATUS ITEMS
Package Discharge Temperature
Airend Discharge Temperature
Injected Temperature
Sump Pressure
Separator Pressure Drop
Coolant Filter
Coolant Filter IN PR
Coolant Filter OUT PR
Inlet Vacuum
Inlet Filter
Total Hours
Loaded Hours
Software Title and Version •
•
•
•
•
•
•
•
•
•
•
•
•
Figure 16: Operator Panel Flow Diagram
The controller automatically returns the display to this CURRENT STATUS
screen from other screens if no buttons are pressed within 0 seconds.
The MAIN MENU screen can be accessed from the CURRENT STATUS screen by
pressing the MAIN MENU button, identified by the words “MAIN MENU” in the
bottom line of the screen directly above the centre button.
NOTICE
Use the UP and DOWN arrows to move between selections . Items will
be highlighted in inverse display mode .
(1) Selecting the highlighted item will display the corresponding menu.
(2) Selecting the highlighted item will place the value in edit mode. This is
indicated by only the value being displayed in inverse display mode.
(3)
The UP and DOWN arrows will alter the value.
Depressing “Cancel” will exit the edit mode and leave the value unchanged.
Depressing “Set” will save the new value and flash the value to indicate
acceptance.
(4)
Depressing “Cancel” will exit the calibration mode.
Depressing “Calibrate” will calibrate the selected sensor.
110812.16.23