Ingersoll-Rand PowerForce PF850, Инструкция по эксплуатации

Страница: 2 / 12

2
WARNING SYMBOL IDENTIFICATION
Always wear eye protection
when operating or perform-
ing maintenance on this tool.
WARNING
WARNING
Always wear hearing
protection when operating
this tool.
Read this manual before
operating tool.
WARNING
OPERATIONS AND MAINTENANCE INSTRUCTIONS
•
Always use clean, dry air at 90 psig (6.2 bar/
620 kPa) maximum at the tool inlet.
•
Lubrication -- Inject approximately 1.5 cc of
Powerforce No. 50 Oil into the air inlet before
starting the tool and after each two or three hours
of operation, unless the air line lubricator is used.
Lubricate with 1.5 cc of Powerforce No. 50 Oil
before storage.
•
Use a 5/16” (8 mm) inside diameter air supply
hose.
•
Impact Mechanism Lubrication -- Remove oiler
screw assembly (3). Add approximately 1.5 cc of
Powerforce No. Oil. Tighten oiler screw assembly.
•
Forward/Reverse Operation -- Press side of throttle
(2) that has the clockwise arrow on it to tighten a
nut. Press side of bar that has the counter--
clockwise arrow on it to loosen a nut. If the threads
are left--handed, reverse the procdure.
•
Speed Adjustment -- Rotate regulator (16) to adjust
the speed of the tool. Number 8 on the regulator
indicates full speed and number 0 indicates
minimum speed.
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR FILTER
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
COMPRESSOR
(Dwg. TPD905--1)
TROUBLESHOOTING
Problem Possible Cause Action
Low speed or tool will not function Lack of lubrication Add 1.5 cc of Powerforce oil #50 to
the tool
Low speed or tool will not function Impact mechanism lubrication Add 1.5 cc of Powerforce oil #50
into impact mechanism
Low speed or tool will not function Low pressure Ensure system regulators are set
properly to have 90 psi (6.2
bar/620 kPa) at the tool inlet.
Low speed or tool will not function Low pressure Ensure proper hose size. Long
hose lengths may require a hose
with a 1/2” ID or larger
Low speed or tool will not function System leakage Ensure connections are tight and
hoses are not damaged
Low speed or tool will not function Debris build up in tool Flush tool with 1.5 cc of Power-
force oil #50
Low speed or tool will not function Regulator (16) in wrong position Ensure that the regulator is in the
proper position
SPECIFICATIONS
Model
Type of
Handle
Drive
in
Impacts
per min
Recommended
Torque Range
H Sound Level
dB (A)
z
Vibrations
Level
Model
Handle in. per min
Ft--lb Nm Pressure Power m/s
2
PF850 Palm 3/8 square 1500 15 to 75 20 to 102 92.3 105.3 2.5
H
Tested in accordance with PNEUROP PN8NTC1.2
z
Tested to ISO8662
All manuals and user guides at all-guides.com