D-1400-4 Page 5 of 16
4
SYSTEM INSTALLATION
4.1.
MOUNT OUTSIDE TRIM, IF USED, PER DIRECTIONS IN TRIM BOX, OR INSTALL OUTSIDE SEX BOLTS.
4.2.
SURFACE MOUNT DEVICE OR THROUGH-BOLT TO TRIM OR SEX BOLTS.
4.3.
LOCATE, MARK, AND DRILL END CAP MOUNTING AND ELECTRICAL ACCESS HOLES:
(A)
LEVEL DEVICE ON DOOR.
(B)
MARK CENTER OF 5/16” DIA. HOLE AT END OF CHANNEL.
(C)
DRILL 9/32” DIA. HOLE THROUGH DOOR.
(D)
DRILL 3/8” DIA. HOLE ON TRIM SIDE OF DOOR USING 9/32” DIA. HOLE AS GUIDE.
(E)
MARK CENTER OF 3/4” DIA. HOLE AT END OF CHANNEL.
(F)
DRILL 3/4” DIA. HOLE THROUGH DOOR SKIN ON DEVICE SIDE OF DOOR ONLY.
WARNING!
THERE ARE NO SERVICEABLE PARTS IN THE POWER SUPPLY (DEX) OR IN THE DELAY
MECHANISM. THE REQUEST TO EXIT SWITCH INSIDE THE DEVICE IS PRESET AT THE
FACTORY. TAMPERING WITH THIS SWITCH CAN CAUSE THE BASIC EXIT FEATURES
OF THIS DEVICE TO FAIL IN AN EMERGENCY. MAKE SURE ALL COMPONENTS ARE
INSTALLED IN ACCORDANCE WITH PREVAILING ELECTRICAL CODES. ALWAYS
REPLACE THE FUSES IN THE POWER SUPPLY WITH THE CORRECT AMP FUSES. THE
DEVICE SHOULD BE TESTED PERIODICALLY FOR PROPER FUNCTION.
MOUNTING HOLES
6 PLACES
3/4” DIA. HOLE
DEVICE SIDE ONLY
9/32” DIA. HOLE, DEVICE SIDE
3/8” DIA. HOLE, TRIM SIDE
TRIM/CYLINDER HOLES
IF REQUIRED
#10-24 X 1” PPHMS
#10-24 X 1” PPHMS
#10-24 X 1-1/2” PPHMS
