Ingersoll-Rand American Standart Nexia, Установка и настройка учетной записи

Страница: 15 / 46

6
Install Silver XM Control
connect the bridge to the wireless router.
1. Use an (RJ-45) Ethernet cable to connect the Bridge to the router, then plug
the Bridge power supply into an AC outlet. (Note: If all LAN ports on the router
are full, you will need to add a switch. Please refer to the Glossary for more
details.)
2. Watch the status on screen as the Bridge connects to the Nexia server.
SUCCESSFUL ENROLLMENT
View “Congratulations” screen that shows check mark by Bridge. Select Continue
and follow on-screen prompts to enroll the control and appliance module.
UNSUCCESSFUL ENROLLMENT
Watch the green indicator light on the Bridge.
•
If you see a 3-blink pattern it is probably because the MAC address was
entered incorrectly. Re-enter the MAC address and repeat the Bridge
enrollment process.
•
If the green indicator does NOT blink, try the Bridge enrollment process
again, after making sure the Ethernet cable is plugged securely into the router
and Bridge. If this does not solve the issue, contact Technical Support at
877-288-7707.
Verify that the green indicator light on the Bridge glows continuously (does
not blink). A steady green light indicates successful communication with the Nexia
server. A steady orange light indicates successful communication with Z-Wave
modules.
If the green light does not glow continuously:
2X green blink: An Ethernet cable is connected but the router is
not connected to the Internet. Confirm whether the Internet service
provider is providing service.
3X green blink: An Ethernet cable is connected and the router is
connected to the Internet, but the Bridge cannot connect with the
Nexia server. Verify that the MAC address is correct. If this is not
successful, try resetting or replacing the Bridge.