Ingersoll-Rand 4MXW1609A1, Руководство по установке

Страница: 26 / 47

Stranded wire connections
1. Cut the end of a cable with a cable cutter or similar; cut and remove about 10mm (3/8”) of
insulation.
2. Using a screwdriver, remove screw(s) from the terminal strip.
3. Using a round stranded wire holder, place a round terminal at each end of the naked wire.
4. Place the round terminal cable in its place and tighten the terminal screw using a screwdriver.
5. Secure the connection cable and the power cable with a cord clamp.
6. After directing the connection cable and the power cable through de isolation tube or conduit,
secure the tube with the use of a cable fastener.
Cable hilado
Tornillo con roldana especial
Tornillo con roldana especial
Terminal
redonda
Terminal
redonda
Tablilla de
terminales
Cable
Cable
Tubo de aislamiento
Tubo de
aislamiento
Sujetador del cable
WARNING
1. Before starting the task, verify the absence of power supply to the indoor unit and the outoor unit.
2. Inappropriate wiring installation in the field can lead to danger of fire and electrocution. Pay special
attention to the unit wiring.
3. Cables should be firmly connected to the terminal block. Inappropriate installation could cause fire.
4. Always fasten the outside covering of wiring with cable fasteners. (If insulation is not fastened, it could
lead to current leaks).
5. Always connect the cable to ground.
Note:
Always ascertain that numbers on the terminal block coincide with the colored cables corresponding to
the indoor unit.
26
Wall Unit