2
WARNING LABEL IDENTIFICATION
FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
Always wear eye protection
when operating or perform-
ing maintenance on this
tool.
WARNING
WARNING
Always wear hearing
protection when operating
this tool.
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before resum-
ing use.
WARNING
Do not carry the tool by
the hose.
WARNING
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
WARNING
Operate at 90 psig (6.2 bar/
620 kPa) Maximum air pressure.
90 psig
(6.2bar/620kPa)
International Warning Label:
Order Part No. ___________
ADJUSTMENTS
TORQUE ADJUSTMENT
To adjust the torque on these Twin Blade Impulse Wrenches,
proceed as follows:
1. Remove the Adjustment Hole Plug.
2. Rotate the Drive Shaft until the Torque Adjustment Screw
is visible in the opening.
3. Using a 2 mm hex wrench, rotate the Adjustment Screw
clockwise to increase the torque output and
counterclockwise to decrease the torque output. Do not
rotate the Oil Plug.
Make all final adjustments at the job.
4. Replace the Adjustment Hole Plug.
CHANGING THE MECHANISM FLUID
To change the Mechanism Fluid in the Impulse Mechanism,
proceed as follows:
1. Remove the Rubber Housing Boot.
2. Using a hex wrench, remove the three Hammer Case Cap
Screws and Lock Washers. Lift the Hammer Case off the
Motor Housing over the Drive Shaft. Remove the
Hammer Case Gasket.
3. Lift the assembled mechanism off the Rotor.
4. Using a 2 mm hex wrench, rotate the Torque Adjustment
Screw clockwise until the Screw stops. Rotate the Screw
counterclockwise until it stops or makes six complete
revolutions.
5. Using a 2.5 mm hex wrench, unscrew and remove the Oil
Plug. Remove the Oil Plug Seal and Oil Plug Seal
Support.
6. With the oil plug opening downward over a container,
rotate the Drive Shaft to purge the fluid from the
mechanism.
7. Thread the Tee Wrench included with the Tool Kit
(Part No. 700A–99 or 1900P–99) into the Piston Stop
Assembly that is 180 degrees from the Torque
Adjustment Screw and pull the Stop Assembly toward the
output end of the mechanism until it stops.
8. Using the syringe and fluid from the Fluid Replacement
Kit (Part No. EQ106S–K400), fill the mechanism with
the fluid furnished in the Kit until the fluid overflows the
fill hole. Model 1100P–EU will require 17 cc of fluid;
Model 1410P–EU, 23 cc and Model 1900P–EU, 30 cc.
See Dwg. TPD1265.
DO NOT SUBSTITUTE ANY OTHER FLUID.
Failure to use the impulse mechanism fluid provided
could damage the tool, increase maintenance and
decrease performance. Use only clean fluid in these
tools.
Содержание 1100P-EU
Страница 31: ...31 NOTES...
Страница 54: ...23...
