INGENIA Everest CORE, Руководство по эксплуатации продукта

Страница: 19 / 58

Everest CORE - Product Manual | Pinout
INGENIA | 08/01/2019 19
65 DNC 66 DNC
67 GND_D Digital signal Ground. Power 68 GND_D Digital signal Ground. Power
69 NC Internally not connected.
Recommended to leave them
unconnected. - 70 NC Internally not connected.
Recommended to leave them
unconnected. -
71 NC 72 NC
73 NC 74 NC
75 1.65V_
REF 1.65 V voltage reference output
with sink/source capability up
to ±10 mA. An excessive current
demand or noise coupled to
this pin can cause a loss of
performance or even
malfunction of Everest CORE:
route by following the best
layout practices. Power
output 76 NC
77 3.3V_R
EF 3.3 V voltage reference output
with sink/source capability up
to ±10 mA. An excessive current
demand or noise coupled to
this pin can cause a loss of
performance or even
malfunction of Everest CORE:
route by following the best
layout practices. 78 DNC Reserved. Do not connect
(leave floating).
79 GND_A Analog Ground. Do not connect
to GND_D directly, use a ferrite
bead or 1
Ω
resistor in
between.
Power 80 GND_A Analog Ground. Do not connect
to GND_D directly, use a ferrite
bead or 1
Ω
resistor in
between.
Power
Notes and naming conventions:
• All pins are tolerant to 3.3 V unless otherwise noted.
• "_P" and "_N" indicates positive and negative of differential signals
• "\" Indicates inverted (active low) signal
• "NC" means Not Connected. Pins marked with NC can be tied to GND or 3.3 V, but best practice is to leave
them unconnected.
• "DNC" means Do Not Connect. Pins marked with DNC must not be tied to any driving voltage, including GND
or 3.3 V.
Motion Control Bus
Everest CORE can be controlled as a slave by means of its proprietary Motion Control Bus (MCB). Check
how in the Summit Series Reference Manual .
