MOUNTING INSTRUCTIONS
These models may be chain or bracket mounted to any ceiling or horizontal surface. Installation must be such that 18"
minimum clearance is maintained around the heater on 4 sides and 36" directly in front. 6" of clearance provided by
mounting brackets is required behind the plane of the face.
Adjustable wall/ceiling brackets are furnished with all SL-series heaters. Brackets have positive stops at 30°and 60°.
When used, they allow heater to be fastened to wall and then tipped down to 60°; for ceiling mount, tilted to 30° max.
Brackets are positioned along a “T” slot on back of unit. You must maintain a minimum distance between the mounting
brackets to ensure a stable installation.
“T” SLOT
INSTALLATION INSTRUCTIONS
WIRING INSTRUCTIONS
OUTDOOR INSTALLATION
This heater must be permanently installed and hard wired by a licensed electrician in accordance with local electrical
codes. Assembly procedure must be performed with no electrical power to unit.
Step 1:
Check UL/CE label on heater for proper voltage.
Step 2:
Follow supplied wiring instructions
The heater is drilled and threaded for standard 1/2" conduit fittings. The installing electrician will need to provide the
appropriate rigid metallic, flexible or liquid tight conduit for the installation location.
Use only copper wire suitable for 90°C.
Observe local electrical code regulations.
Step 1:
Heater must be mounted with reflector angled down.
Step 2:
All electrical connections must be in compliance with the National Electric Code and local codes for outdoor wiring.
Step 3:
Use only wiring components UL/CE listed for outdoor use with IP X 4 minimum rating.
MAINTENANCE INSTRUCTIONS
Before performing any maintenance, power must be disconnected and the heater cool to touch.
Heater housing, reflector and heating element can be rinsed with a hose or wiped down with isopropyl alcohol, acetone,
or glass cleaner, using a clean, scratch-free rag or paper towel. Any oxidation, surface rust or discoloration can be
removed with stainless steel cleaner or metal polish on the bare metal surface.
Make sure all water, solvents or cleaners are removed and the heater is dry before reconnecting power.
3
