8
2.3 I / O Terminal Wiring Diagram
The I / O terminal is located on the serial communication cable. If the equipment is
connected to external signals or to drive external equipment, it is necessary to use this
terminal to connect with external equipment. The drawing of the terminal is shown as
below, and the serial number and definition of the terminal are shown in the table
。
Note
①
: It depends on the voltage of the power supply connected to the serial port
cable.
Note
②
: The valid level value can be set, and the default is 24VDC.
Terminal
serial number
Terminal
name
specific
description
Remark
1
24V
Power input (output)
Power output: can provide power supply for external
equipment (Note
①
) Power input: can be connected to
20-30V for power supply
2
GND
GND
GND
3
IN1
input signal 1
Logic level (default low level takes effect)
4
IN2
input signal 2
Logic level (default low level takes effect)
5
GND
GND
GND
6
COM- (+)
Voltage output
terminal (+)
It forms a voltage feedback with OUT1-OUT4,
5V\24V\ external voltage (not more than 36VDC)
7
OUT1
Transistor output 1
Internal pull-up is optional, active level is optional (Note)
8
OUT2
Transistor output 2
Internal pull-up is optional, active level is optional (Note)
9
OUT3
Transistor output 3
Internal pull-up is optional, active level is optional (Note)
10
OUT4
Transistor output 4
Internal pull-up is optional, active level is optional (Note)
11
PWMOUT
External light source
control signal
3.3V level output duty cycle can be controlled
12
GND
GND
GND
13
GND
GND
GND
14
24V
Power input (output)
Power output: can provide power for external devices
Power input: can be connected to 20-30V for power supply