Installation Manual
| ACINV Series 1RU Rack Mount Inverters
6
7
+1 (208) 635-6400 | www.transtector.com
+1 (208) 635-6400 | www.transtector.com
SINEWAVE
INVERTER
1.26”
(32.0mm)
1.73”
(44.0mm)
1.12”
(28.5mm)
16.4”
(416.8mm)
3.94”
(100.0mm)
1.1”
(28.0mm)
1.30”
(33.0mm)
1.30”
(33.0mm)
3.78”
(86.8mm)
1.1”
(28.0mm)
3.42”
(86.8mm)
7.17”
(182.0mm)
2.48”
(63.0mm)
1.57”
(40.0mm)
1.26”
(32.0mm)
1.73”
(44.0mm)
0.12” (3.0mm)
0.12” (3.0mm)
19.06” (484.0mm)
18.31” (465.0mm)
19.06” (484.0mm)
18.31” (465.0mm)
TOP VIEW
REAR VIEW
(as seen from back)
SIDE VIEW
FRONT VIEW
1.3 Mechanical Drawings
2. Introduction
ACINV Series is an advanced range of pure sine wave output power inverters employing microprocessor technology.
For optimum performance and life expectancy they must be installed and used properly.
Please read the instructions in this manual BEFORE installing the unit and switching it on.
2.1 Front Panel Description
SINEWAVE
INVERTER
ON/OFF
SWITCH
PROGRAMMING
DIP SWITCHES
LEDs & DISPLAY
FUNCTION
SELECTOR
2.1.1 ON/OFF Switch
Switches the inverter electronics ON and OFF. Should be in the OFF position during installation.
2.1.2 Function Selector, LEDs & Display
When the function selector is sequentially pushed the display shows the reading associated with the actual
parameter indicated by the top row of LEDs in the sequence:
VAC
-
AMP
-
WATT
-
VDC
-
TEMP
-
Hz
In the event of a fault condition this will be indicated on the display. See section 2.8.
The
ONLINE
LED indicates that a Utility or other external AC source is connected to the unit.
The
BYPASS
LED indicates that the unit is shutdown and the Utility or other AC source has been switched
to the outlet sockets.
IMPORTANT NOTE: In the event of a DC supply failure or if the ON/OFF switch is set to the OFF
position all LEDs and the display will be switched off. If a Utility or other AC source is connected to
the unit this will automatically be fed to the outlet sockets, unless the AC Mains Breaker mounted
on the rear panel is switched off.
2.1.3 DIP Switches
The DIP switches are used to set output frequency, RS232 baud rate and output voltage setting. See
sections 7.1 and 7.2 for full details.
