28
TEC-VS-219-1605-V01
Enable:
Enable/Disable motion detection function
Sensitivity:
Support levels 1-8, where 8 is the highest level.
Buzzer:
Enable/Disable buzzer alarm when a motion is detected. The users can choose the buzzer
alarm to be raised for 10,20, 40 or 60 seconds)
Post Recording:
Select the time for which the video has to be recording once the motion is
finished. The users can set this time as 30 seconds, 1 minute, 2 minutes or 5 minutes.
Picture 5-25
Latch Time:
When a motion is detected, the alarm time can be set as 10 seconds, 20 seconds, 40
seconds and 60 seconds.
Alarm Out:
Check to activate Alarm relay out when a motion is detected.
Show Message:
Messages will be displayed on the screen when moving object is detected.
Send Email:
Check to send Email notification when a motion is detected.
Full Screen:
Check to pop up the channel when a motion is detected.
Area:
Click to enter into the interface shown in Picture 5-25 to set the motion detection area to be
monitored.
A single channel is divided into 15×12 (PAL) or 15×10 (NTSC) configurable grids. The red grids
indicate that the motion detection in the area is enabled while the white semitransparent ones
indicate that the motion detection in the area is disabled. After the setting is complete, right click the
mouse button to return and click “Save”.
Record Channel:
Check to record the selected channels when motion is detected.
Analog Channels:
Select the Analog channels to be recorded when motion is detected.
IP Channels:
Select the Analog channels to be recorded when motion is detected.
Copy:
Copy the parameters of the selected channel to any other or all channels
5.2.1.20 Alarm
Go to “Main Menu”
“Alarm”
“Alarm” to enter into the alarm interface menu shown in Picture 5-26.