Application Note
5
Rev. 1.0
2017-08-02
TLE5014 Programmer
General description
1.2
TLE5014 satellite board
A satellite board is provided with a TLE5014D dual channel angle sensor which can be connected to the shield
of the Eval Kit. The TLE5014 on this board is pre-programmed with the following settings:
• SENT single secure sensor (incl. rolling counter and inverted nibble)
• UT=3.0 µs, pause pulse, no short serial message
The sensor is fully configurable and can be set to different protocol options and interfaces (SENT, SPC, PWM).
For a SPC bus mode:
• channel 1 has the default hard-wired address ID=0
• channel 2 has ID =1
It is possible to change the address by changing the “zero-ohm” resistors on the board (see figure and table
below).
Figure 4 Satellite
board
Table 1 Change
the
address
RIF1_1C
RIF1_1G
RIF2_1C
RIF2_1G
ID = 0
x
x
ID = 1
x
x
ID = 2
x
x
ID = 3
x
x
