User Manual
13 of 47
Revision 1.4
2020-07-16
EVAL-M3-IM564 User Manual
iMOTION
™
Modular Application Design Kit
Getting started with EVAL-M3-IM564
3
Getting started with EVAL-M3-IM564
In order to run the motor system, a combination of the iMOTION
™
MADK power board (EVAL-M3-IM564) and the
matching MADK control board is required. The iMOTION
™
software tools, MCEDesigner and MCEWizard, are also
required in order to initially set up the system, as well as to control and fine-tune the system performance to
match users’ exact needs. This chapter provides more details on setting up the system and getting started with
the iMOTION
™
MADK development platform.
Note:
If you are using an EVAL-M3-102T control board, please make the following changes to better
match EVAL-M3-IM564 for OPA’s gain and PFC OCP level.
1. Delete R6 and R10 of EVAL-M3-102T
2. R13 of EVAL-M3-102T from 2 kohm change to 0 ohm
3. R25 of EVAL-M3-102T from 1 kohm change to 0 ohm
4. R8 of EVAL-M3-102T from 24 kohm change to 470 ohm
R9 of EVAL-M3-102T from 470 ohm change to 1.65 kohm for PFCTRIPREF
3.1
Setting up the system
After downloading and installing the iMOTION
™
PC tools (MCEWizard and MCEDesigner), the following steps
need to be taken in order to run the motor. Refer to user manual for iMOTION
™
MADK control board such as
(EVAL-M3-102T), MCEWizard and MCEDesigner documentation for more information.
Figure 4 shows the system connection using EVAL-M3-IM564 and control board (used control board EVAL-M3-
102T for example).
Figure 4
System connection example using EVAL-M3-IM564
PC-USB
Connector
AC Power
Input
Motor Phase
Outputs
PFC
Inductor