HOW TO INSTALL: INFANT POSITION (0-9kg)
For dimensions of restraint when installed, see Fig. 3C opposite.
To be used only in a rearward-facing position for a child weighing up to 9kg and with a length of up to 700mm
IMPORTANT: DO NOT use A ReAR FACINg ChIlD ResTRAINT wheRe AN AIRbAg Is FITTeD IN FRONT OF The seATINg POsITION.
normally this restraint is used in the rear seat but in certain vehicle types, e.g. sports cars/mini cars,
etc. where the rear seat is too small, the only possible position is the front passenger seat, adjusted
as rearward as possible. The tether strap must be attached to the anchorage point provided, and
corresponding rear seating position should not be used. (an extension strap may be required to reach
the anchorage point in certain instances.) [extension strap part no. ccs003.]
noTe: check the measurements between the front of the seat back of the rear seat and all front seats
in the car in which the child restraint is intended to be used, to ensure that the space is sufficient.
sTep 1
your restraint has two red
levers on it. one on the front
of the body section and one on
the base. lift up the red “recline
lever” on the body section and
recline the body section as
far as possible.
(see figures
opposite on page 4).
sTep 2
position restraint on vehicle
seat so the higher section of the
base is positioned against the
vehicle seat back.
(see figure
3a or 3c opposite).
The body
section could face rearward or
forwards at this stage.
sTep 3
extend the adult lap or lap/sash
belt
(as shown in figure 2a)
.
holding the vehicle
belt
(as shown in figure 2a)
(note the position of the hands)
loop it over the arm of the base
section
(position a in figure
2b)
. still holding the belt as above slide the vehicle belt under the front
of the car seat and around to the other side of the car seat.
(refer to
figure 2b and 2c – important figures 2c and 2d are viewed from the
opposite side of the car seat to figures 2a and 2b)
. loop the vehicle
belt over the arm of the base as shown in
figures 2d
and engage the
buckle tongue of the vehicle belt with the buckle
(refer to figure 2d).
sTep 4
pull the sash (shoulder) section of the vehicle seat belt very tightly by
holding the sash section with one hand and the car seat with the other
(refer to figure 2e).
it sometimes helps to rock the car seat as you
pull the sash section. fit the metal double ‘T’ belt clamp to clamp the
sash and lap sections of the vehicle belt together (see page 11) for
further instructions). The correct position of the double ‘T’ belt clamp
is shown in
figure 4
.
sTep 5
ensure the body section is facing the rear of the vehicle
(i.e. as in figure 3c).
if it is facing the front of
the vehicle
(as in figure 3a),
push down the ‘Turn-a-Tot’ lever located at the front of the base and swivel
the body section through 180º so it faces the rear of the vehicle
(see figure 3b and 3c).
FIGURE 2A
FIGURE 2B
FIGURE 2C
FIGURE 2D
FIGURE 2E
page 3
figures 2c and 2d are Viewed from The opposiTe side of
The car seaT To 2a, 2b and 2e
A
PROCEDURE FOR REARWARD FACING MODE