PAGE 10
TO REPLACE THE HARNESS
STEP 1
Place one end of the harness through the
required shoulder slot hole
(See Arrow 1 in
Fig. 18)
then up and over the shoulder rod
(See Arrow 2 in Fig. 18)
and connect to the
metal spreader plate by passing the webbing
through the “gate”
(See Arrow 3 on Fig. 18
and Fig. 15 on Page 8).
STEP 2
Feed the other end of the harness and the
buckle tongue through the thigh slot
(See
Arrows 4 in Fig. 18).
STEP 3
Continue to feed the end of the harness and
the buckle tongue in the gap BETWEEN THE
SEAT SHELL AND THE METAL SLIDE in the
direction of
Arrows 5 and 6 in Fig. 19
and up
through the other thigh slot
(See Arrow 7 in
Fig. 19).
STEP 4
Engage buckle tongues in the buckle
and feed the end of the harness
through the required shoulder slot hole
(See Arrow 8 in Fig. 20).
Ensure that
the shoulder slot hole is the same level
as used in Step 1.
STEP 5
Pass the end of the harness over the
shoulder rod
(See Arrow 9 in Fig. 20)
and
then down to the metal spreader plate
and secure through the “gate”.
(See
Arrow 10 in Fig. 20).
STEP 6
Test the harness is securely fastened
and is without any twisting. Ensure
buckle is in the middle of the restraint.
THE RESTRAINT HARNESS
IS NOW READY FOR USE.
SHOULDER
ROD
SLOT
HOLES
METAL
SPREADER
PLATE
BUCKLE
TONGUE
THIGH
SLOT
FIGURE 18
FIGURE 19
FIGURE 20
THIGH
SLOT
SEAT
SHELL
SEAT
BASE
BUCKLE
TONGUES
SHOULDER
SLOT
HOLES
METAL
SPREADER
PLATE