Network Connections
Page 10 of 15
SCR808 | EN
Switch
On the IP controller board there are two network connectors. The IP controller board can be used as a
switch because of the Ethernet switch chip on board and can be placed between a wall outlet and an
existing Ethernet device (like a printer or multifunctional device). The speed of the network devices is
10/100 Mbit.
Power over Ethernet (PoE)
If the power supply adapter is used both connectors can be used normally to connect to the wall outlet
and the Ethernet device. But the IP controller board can also be supplied with energy by a Power over
Ethernet switch. In this case the connection from the PoE switch must be made to the "PoE" Ethernet
connector, the Ethernet device can be connected to the "no PoE" connector.
If the cables are connected falsely (ie. the PoE switch is connected to the "no PoE" Ethernet
connector), nothing will be damaged. In that case the IP controller won't have energy and will not
operate. Switching the Ethernet cable to the "PoE" connector will activate the IP controller board.
IP READER OVERVIEW
Power over
Ethernet
No Power over
Ethernet
Orange LED =
Blinking
Green LED = On
Orange LED = On
Green LED = Blinking
IP Controller Board
Ethernet
Connections
IP Controller Board
IP Controller Board LED's
-->
-->
-->
-->
-->
RS232
Led on = Communication between
card reader and controller board is OK.
RUN
led on = Program in the micro on the IP
controller board runs correctly.
CARD
led on = controller board detects card
being presented to card reader.
Green led on
= Ethernet connection with
internal switch chip
Orange led blinking
= data being transferred
trough Ethernet connection
