IndigoVision Compact NVR-AS 4000, Руководство пользователя

Страница: 33 / 38

User Guide - v14 33
7
T
ROUBLESHOOTING
This chapter provides troubleshooting information to resolve common issues.
Monitor recordings
To monitor jobs that are currently recording, use IndigoVision’s Control Center application.
Control Center allows you to monitor all jobs on your NVR-AS. It allows you to set up
recording jobs on NVRs on a visible network. You can also use it to view any existing jobs
and their current state (enabled, disabled, recording, etc).
If a transmitter shows Trying to record in Control Center’s recording schedule this indicates
a problem with the transmitter. You should check the network connections and that the
device is switched on. You should then try to access the device’s Web Configuration pages.
NVR Alerts
You should pay particular attention to the following alerts in Control Center:
• Disk Full
Disk full alerts indicate that the NVR-AS disk is full, and that the NVR-AS cannot
delete any recordings, for example, because they are protected. Use Control Center to
check for recordings marked as Protected and unprotect these recordings.
• Maximum Recordings
These indicate that the maximum number of recordings has been exceeded. This may
be because there are too many short recordings.
Recording failure alerts
Recording failure alerts indicate that one or more transmitters are not recording correctly.
• Check the network connectivity between the transmitter and the NVR-AS.
• Ensure that the maximum number of licensed streams has not been exceeded.
Network failure alerts
If there are network redundancy failures, then configured alerts are seen in Control Center
and any configured device fault detectors are activated.
► For more information, see "Status Monitoring" on page 27