24
These jumpers allow you to route the control signal to the binary
input of slot 1. To do this, you must set the jumpers as shown in
Figure 8
on page 23.
Table 1
on page 24 shows the truth table for this control signal:
Condition
Signal Level
Both supplies connected and operational
1
Both supplies connected but one not operational
0
Only one supply connected
0
Table 1
Truth table for binary input control signal
Configure the Binary Input
When you have set the jumpers, you must use the Web
Configuration pages to configure the binary input for slot 1, as
follows:
1. Enter the IP address of the card in slot 1 into a web browser.
2. Click Binary IO on the left side of the page. A screen similar to
Figure 10
on page 24 appears:
Figure 10
Binary input configuration
3. Check “High to Low” and make sure “Low to High” is
unchecked.
4. Click
Submit
to save your changes.
Содержание 10-Channel Rack
Страница 1: ...IndigoVision 10 Channel Rack Hardware Guide...
Страница 6: ......
Страница 10: ......
