Index ABC 2 Series, Руководство по эксплуатации

Страница: 40 / 118

A180 - Clean the work area
Orientation
To ensure consistent quality, high availability and value retention, the machine must
be regularly cleaned, depending on the operating conditions.
Of course, this is influenced by various factors. The use of emulsion as a cooling
lubricant requires a more frequent and intensive cleaning.
Compared to machining producing long chips, machining producing short chips
requires a considerably higher maintenance effort. Short chips, such as in the
machining of brass or cast iron, form chip accumulations or become deposited in
small cracks and corners. These positions must be cleaned regularly to avoid
damage to the respective components.
Areas such as telescopic covers, rubber seals, sealing lips or wipers are particularly
affected points. Frequent cleaning of these areas is particularly important.
Requirement
Only the agents described in the documentation may be used for the
cleaning and after-treatment of the machine.
Always use the proper tool to remove chips.
The following tools are required for cleaning:
- chip hooks,
- chip brushes,
- spray bottles of cleaners or cooling lubricant,
- a sufficient quantity of rags,
- oil to apply to the telescopic plates and all other bare parts by spaying or by
brushes.
Procedure
1.
Caution
Chips and projecting tools in the work area.
Cuts.
Use of personal protective equipment such as safety goggles
and gloves, and appropriate tools.
Remove chips from the work area.
2. Chip accumulation particularly in the area of thetool carriers and the work area
door.
3. Flush work area with cooling lubricant.
4. Wipe clean with rags.
5. Apply an oil film to bare metal plates and telescopic covers.
6. Examine any visible damage, and repair or replace, if necessary.
Maintenance Summary - Care activities
34
Maintenance Instructions
ABC.2
DIE244EN - 15.08.2022