Indesit K 645 V.C/G, Инструкция по установке и эксплуатации

Страница: 6 / 16

6
c) Minimum regulation of the hob burners:
•
turn the tap to minimum;
• remove the knob and adjust the regulation screw, which is
positioned in or next to the tap pin, until the flame is small but
steady.
N.B.: in the case of liquid gas, the regulation screw must be
screwed in to the bottom.
• check that the flame does not turn off when you turn the tap
quickly from high to low.
d) Regulating the primary air of the burners:
The primary air of the burners requires no regulation.
Important
On completion of the operation, replace the old rating sticker
with one indicating the new type of gas used. This sticker is
available from our Service Centres.
Note
Should the pressure of the gas used be different (or vary) from
the recommended pressure, it is necessary to fit a suitable
pressure regulator onto the inlet pipe in compliance with current
National Regulations relative to “regulators for channelled gas”.
Raised border assembly (only on a few models)
To assemble the raised border correctly, please follow the
instructions below:
· Unscrew the 4 screws and the 2 spacers on the rear
part of the worktop;
· Place the raised border on the rear part of the worktop;
·
Screw the raised border onto the worktop using the
four screws you previously removed, ensuring that you
reposition the spacers on the outermost screws.