MMP-1: INSTALLATION & OPERATION MANUAL
PAGE 6
1. USB: The USB port allows users to plug USB thumb drives into the MMP-1. To playback music files from a
USB drive place, the MMP-1 into USB playback mode via the MODE button.
*Note: USB drive must be formatted as FAT32.
2. Sig LED: The signal LED will illuminate green when there is audible audio playback active on the MMP-1.
REAR PANEL CONNECTIONS
1. RJ45 connector: The RJ45 connector is used to power the MMP-1 and also serve as an audio bus
to remotely feed audio to other devices, such as mixers, mixer amplifiers, amplifiers, pre amps and
powered speakers.
*Note: Please see connection diagrams and cable recommendations on page 9 for more details.
2. LINE IN: This is a balanced mono line input. Please connect the JST3 to XLR Female cable adapter
(included) to connect balanced LINE output of a device. To hear audio connected to this port please
select LINE mode via the MODE button on the front panel of the MMP-1.
*Note: The 3.5mm stereo input on the front panel and the balanced input on the rear panel are shared
inputs. Audio signal will be audible from both inputs when in LINE mode if both of these audio inputs are
connected at the same time.
3. LINE OUTPUT: This is a balanced mono line output. Please use the JST3 to XLR Male adapter cable
(included) to balanced line input of a device.
*Please see connection diagram and cable recommendations on page 9 for more details.
BT OPERATION
The MMP-1 is capable of audio streaming from compatible BT devices. The BT transmission range between
the MMP-1 and streaming device should be within 20 metres of the MMP-1. Only one streaming device can
be connected to the MMP-1 at a time.
BT Paring
To pair your streaming device to the MMP-1 use the mode button to cycle through the different modes until
you see the blue LED light. In default the MMP-1 is unpaired and the blue LED will flash slowly.
Press and hold the play/pause button for 8-10 seconds until the blue LED flashes rapidly. Go to the BT
settings on your streaming device and pair with the MMP-1. The default BT id is “inDESIGN MMP-1”.
1
2
3
Содержание MMP-1
Страница 1: ......