Inax DV-S618, Руководство пользователя

Страница: 33 / 62

32
Useful Information
Flushing the Toilet Manually
The toilet bowl cannot be ushed using the remote control during a power outage.
Use the following procedure to ush the toilet.
Flushing the Toilet Manually During Power Outages
Remove the side cover on the left side
when facing the toilet body ( ☞ Page 45).
* The red toilet ushing lever used during power
outages should now be visible.
Side cover Red ushing lever
Turn the red ushing lever toward you and
hold it in this position for approximately 5
seconds.
* Water will ow around the toilet bowl to ush waste
to the bottom of the toilet bowl.
Inside the
toilet bowl
Once the waste has reached the bottom of the toilet
bowl, turn the red ushing lever back to the rear and
hold it in this position for approximately 5 seconds.
* Water will ow to ush the waste out of the bottom
of the toilet bowl.
Inside the
toilet bowl
Once the waste has been ushed, turn the red
ushing lever toward you again and hold it in
this position for approximately 5 seconds.
Water will ow around the toilet bowl to ll the bottom
of the toilet bowl with water.
Once the toilet bowl is lled with water, release the lever.
The lever will return to its original position
automatically and the ow of water will stop.
Inside the
toilet bowl
Reattach the side cover (
☞
Page 45).
Flushing the Toilet in the Event of a Suspended Water Supply
Pour a bucket of 5 to 6 liters of water into the toilet while being careful not to spray
water to ush waste in the toilet.
Then pour another 3 to 4 liters of water into the toilet to ll the toilet bowl to normal
levels.
* Pour more water a little faster if the waste does not ush properly.
* Perform the same procedure for a partial ush.
[CAUTION]
Be careful not to spill water onto the oor when carrying water in a bucket or
when pouring water into the toilet.
Do not allow water to splash onto outlets.