Inax CW-RS3-W, Инструкция по установке и эксплуатации

Страница: 40 / 44

40
Posterior cleaning and bidet cleaning (continued)
Warm air drying
Deodorizing
Heated toilet seat
Spray water is not
warm.
Water temperature is not set to an
appropriate temperature.
Press the water temperature button
and adjust the water temperature to the
appropriate level. (See page 22.)
The wash or bidet function was
used for a long period of time.
The water takes about 3 minutes to warm
back. (See page 20.)
Power save is activated. Cancel power save. (See page 26.)
Cause Remedy Symptom
Drying function does not
operate.
The occupied seat sensor is not
on. Sit back fully on the toilet seat, or change the
way you sit on the toilet. (See page 20.)
Certain clothing is difficult for the
occupied seat sensor to detect
even if the seat is occupied.
Place your hand close to the occupied seat
sensor. (See page 20.)
Dryer air is not warm.
Air temperature is not set to an
appropriate level.
Press the dry button and adjust the air
temperature to the appropriate level. (See
page 25.)
Warm air stops suddenly
before finishing.
The drying function has been used
for 4 minutes or longer.
Press the dry button again. (See page 25.)
Cause Remedy Symptom
The deodorizing fan
does not switch off.
Is any paper covering the seat
sensor?
Please remove any paper blocking the seat
sensor.
Cause Remedy Symptom
The toilet seat is not
warm.
Seat temperature is not set to an
appropriate level.
Press the seat temperature button and adjust
the seat temperature to the appropriate level.
(See page 22.)
Power save is activated. Cancel power save. (See page 26.)
Toilet seat becomes
less warm when
seated long.
The toilet seat heater auto off
function is operating.
Cancel the toilet seat temperature auto off
function. (See page 27.)
Cause Remedy Symptom
GCW-1220-W-08110.indd 40 GCW-1220-W-08110.indd 40 2011/07/12 11:12:39 2011/07/12 11:12:39