Inax CW-RS3-W, Инструкция по установке и эксплуатации

Страница: 15 / 44

15
8. Mounting the remote control
7. Positioning the remote control unit
Battery
Back cover
Bracket
Wood screw
6 mm dia.
Plastic anchor
Wood screw
Bracket
Bracket
Remote
control unit
Plastic anchor
φ
6mm
33 mm
Bracket
Wood screw
(1) Open the back cover of the remote control
unit and insert the batteries (two AA size
batteries).
(2) Place the remote control unit in the position
you would like it to be in, sit down on the toilet
seat and press the stop switch.
(1) Place the bracket on the wall depending on the
wall material as follows, then mount it in the
desired mounting position.
• If mounted in plywood paneling 5 mm or
greater in thickness:
Fasten the bracket to the wall with the wood
screws.
• If mounted either in plywood paneling 5
mm or less in thickness or in gypsum
board:
A) In plywood paneling, drill holes with a
diameter of 6 mm; in gypsum board, drill
holes with a diameter of 5 mm.
B) Using a hammer, gently drive the plastic
anchors into the holes.
C) Fasten the bracket securely to the
anchors using wood screws. As you
tighten the screws, they are hard to turn at
fi rst, then gradually get easier to turn, and
then are hard to turn again.
(2) Align the remote control unit with the bracket
and then push it down onto the bracket.
CAUTION
• Install the batteries with the positive and negative poles facing the
correct direction in accordance with the marks on the remote control unit
case.
•
Do not use old and new batteries together.
• Use the batteries in the pack.
CAUTION
• Water will spray from the nozzle if the Shower or Bidet switch is pressed,
so exercise caution.
•
Check to make sure there is enough space above the remote controller to
mount or remove the controller at its mounting position.
• After you make sure the power lamp blinking, pull the power plug out of the
receptacle at once.
GCW-1220-W-08110.indd 15 GCW-1220-W-08110.indd 15 2011/07/12 11:12:20 2011/07/12 11:12:20