USER MANUAL
PAGE 10
INSTALLATION INSTRUCTIONS
Fitting the Power Supply cable
Opening the terminal board:
► Using a screwdriver, prise open the side tabs of the terminal board cover;
► Pull open the cover of the terminal board
To install the cable, proceed as follows:
► Remove the wire clamp screw and the three contact screws L-N and EARTH
► Fasten the wires beneath the screwheads using the following color scheme:
► Blue (N), Brown (L), Yellow- Green (EARTH)
► Fasten the supply cable in place with the clamp and close the cover of the terminal board.
Fitting the Power Supply cable
Install a standardised plug corresponding to the load indicated on the data plate. When connecting the cable directly to
the mains, install an omnipolar circuit-breaker with a minimum contact opening of 3mm between the appliance and the
mains. The omipolar circuit breaker should be sized according to the load and should comply with current regulations (the
earth wire should not be interrupted by circuit breaker). The supply cable should be positioned so that it does not reach a
temperature of more than 50°c with respect to the room temperature, anywhere along its length.
Before making the connection, check that:
► The electrical safety of this appliance can only be guaranteed if the oven is correctly and efficiently earthed; if you have
any doubts call in a qualified technician to check the system. The manufacturer declines all responsibility for damage
resulting from a system which has not been earthed.
► Before plugging the appliance into the mains, check that the specifications indicated on the date plate (on the
appliance and/or packaging) correspond to those of the electrical mains system of your home.
► Check that the electrical capacity of the system and sockets will support the maximum power of the appliance, as
indicated on the data plate. If you have any doubts, call in a qualified technician.
► If the socket and appliance plug are not compatible, have the socket replaced with a suitable model by a qualified
technician. The latter, in particular, will also have to ensure that the cross section of the socket cables are suitable for
the power absorbed by the appliance. The use of adapters, multiple sockets and/or extensions, is not recommended.
If their use cannot be avoided, remember to use only single or multiple adapters and extensions which comply
with current safety regulations. In these cases, never exceed the maximum current capacity indicated on the single
adapter or extension and the maximum power indicated on the multiple adapter. The plug and socket must be easily
accessible.
WARNING!
It is essential to use specific soft wire is bought from the manufacturer or an authorised electrical
distributor to replace if the electrical soft wire has been broken.
