inada HCP-WG1000A, Руководство по эксплуатации

Страница: 10 / 80

11
BEFORE USE
Caution
● When the remote control is inserted into the remote control pocket, be careful of the remote control cable.
Use with the remote control inserted
into the remote control pocket as
shown in the fi gure on the right.
BEFORE USE
How to Connect the Main Power
① First, plug the power
cord into the cord
connector located at the
back of the chair.
Then, plug the other
end into the wall outlet. ② Set the main POWER
switch located at the
back of the chair to ON.
*If the main POWER switch is turned ON while the rollers are stopped partway, they will automatically return to the storage position and then stop.
Warning
● Do not use with any type of transformer device.
→ May result in damage to the chair or electric shock.
Caution
● Before plugging the power cord into the wall outlet, make sure that the main POWER switch is set to OFF.
● Make sure that the plug on the power cord is inserted fully into the wall outlet.
● Before using the chair for the fi rst time, turn on all the switches in order as indicated in this Operating Manual to check
that the chair is operating properly.
How to Install the Remote Control Pocket
The remote control pocket can be installed on an armrest.
While the armrest is raised, fi rmly install the remote control pocket onto the velcro on the rear side of the armrest.
To remove, perform the installation procedure in reverse.