Imperial Kitchen Ventilation 3000PS1, Инструкции по установке и информация о гарантии

Страница: 3 / 16

Flush Mount Installation Details:
MODELS: MODELS: MODELS:
G3000SD2 G3000SD4 G3000PS1
3000SD2 3000SD4 3000PS1
CABINET: Be sure cabinet bottom is level, side to side and front to rear.

For the “SD” units prepare cabinet by cutting an 8” x 8” hole in bottom, 3/4” from wall
and on Center line.

For the “PS1” units prepare the cabinet by cutting a 10 3/8” (D) x 20 1/4” (W) hole in
the bottom, 1/2” from wall and center line.

Shelves and top to be cut to clear 7” round pipe. Make sure to cut holes for electrical
wires.
NOTE: Bolts, washers and nuts supplied. Remove the Drawer before positioning the hood
under the cabinet. (See next page on how to remove drawer.)

Remove Black Tape that holds dampers in closed posi-
tion. *It is NOT recommended to use 2 dampers during
installation. You have the option to put a external damper
or use the existing damper already on the unit.

Position hood against cabinet bottom and against the wall.
Mark the underside of cabinet through each key-hole for
location of each bolt hole.

Drill 3/16” holes through cabinet bottom. Insert bolts with small
washer under head of bolt through cabinet bottom from inside
the cabinet.

Again, position hood under cabinet with bolts through
key-holes. Starting with front key-holes, place large washer on
bolt, attach the wing-nut to bolt, secure both front wing-nuts.
Push hood back against wall, secure large washer and the
wing-nuts on rear bolts.

Re-install the drawer.

Connect duct and tape all joints.

Replace Filters
ELECTRICAL:

Bring enough wire into cabinet to reach in front of vent pipe.

Enter the cabinet 3 1/4” left of center for (SD unit) or 2 1/4” for the (PS1 unit).

Remove electrical box cover before mounting the hood.

After hood is mounted attach house wires to leads in hood.

Secure locknut to conduit and check wiring for compliance with all local codes.

Replace electrical box cover.
Units are to be hard wired. It is not recommended to add a power-cord. Adding a
power cord can loosen existing wires inside junction box causing electrical failure.
cord.
Duct Sizes Indicated in Model # (Ex: 3030PS1-8)
** - 8 = 8” DUCT PIPE
PROPERTY OF HOME OWNER, DO NOT THROW AWAY!
SD2 or SD4
PS1
Black Tape on Damper