Impecca VP-120K, Руководство пользователя

Страница: 9 / 55

9
ENGLISH
FRANÇAIS
ESP
AÑOL
INSTALLING YOUR PROJECTOR
The projector can be placed on a table or other similar, stable surface. It can also be mounted to
the ceiling. Professional installation is recommended for a ceiling mount installation.
Warning: To avoid danger, please do not install the projector near water or extreme heat
Do not block the ventilation on the back of the projector. 10 cm (4 inches) of free space
must be available around the entire unit.
DETERMINING DISTANCE AND LOCATION FOR THE PROJECTOR
You may wish to measure the distance from the lens to the surface that the image will be projected
on. This will give an idea of how big the projected image will be.
Screen or
Projection Surface
72
"
60
"
50
"
45
"
37
"
Center of the lens
IMPORTANT:
For any type of installation other than front table projection, you will need to rotate
the image. This can be done with the Flip button, or by noting the Rotate setting below and chan-
ging it in the Options section of the Settings menu (covered later in the guide)
PLACING THE PROJECTOR ON A TABLE
Table
(Front Projection)
Table
(Rear Projection)
“Flip” button used to reverse image
Ceiling Mount
(Front Projection)
Ceiling Mount
(Rear Projection)
“Flip” button used to reverse image
Select a safe, stable surface and center the projector
lens on the surface it will be projecting on. Try to make
sure that the projection surface is parallel with the front
of the projector so that the projection is casting to the
screen directly and is not angled to the left or right.
The angle adjustment knob can later be used to raise or
lower the angle of the projector. This will raise or lower
the projected image.
Table
(Front Projection)
Rotate Setting: 0
Table
(Front Projection)
Rotate Setting: 3