IMO i3N Series, Руководство пользователя

Страница: 63 / 94

63
11.7 Ethernet Configuration – IP Parameters
For primary operation, the IP address, Net Mask, and Gateway should be set in the LAN config of the i3
configurator Hardware Configuration
. There are options to get IP parameters from the LAN Config or to
get parameters from registers. The following points on IP parameter configuration should be considered.
• IP Parameters in Non-Volatile RAM: The IP parameters of the i3 configurator LAN Config are
written to non-volatile RAM on power down.
• “i3 configurator LAN Config”/ “Get Settings from” Configuration : When ‘Get settings from’ is set
to Configuration, the IP parameters specified under ‘Default Settings’ is used after downloading
to the controller. After power cycle, the unit reverts to the last downloaded i3 configurator LAN
Config that was loaded into non-volatile RAM at power down.
• “i3 configurator LAN Config” / “Get Settings from” Register : When ‘Get settings from’ is set to
Register, the IP parameters are retrieved from the i3 registers assigned in LAN Config. Configured
registers must be populated with the desired IP parameters. When the i3 is placed back into run
mode, it reverts to the registers for IP parameters.
11.8 Ethernet Module Protocol Configuration
The Protocol Support area contains a list of the resident protocols supported by the platform being
configured. To activate a protocol, check its checkbox.
For protocols that require additional configuration, click on a listed protocol to select it and then click the
Configure Selected Protocol button. This will open a new dialog with configuration options for the selected
protocol.