ImmersionRC vortex 250 pro, Инструкция по эксплуатации

Страница: 17 / 65

GoPro Camera Mount
The Vortex 250 Pro ships with a GoPro camera ‘recliner’ kit, which may be optionally installed.
This kit tilts the GoPro camera to an angle appropriate for high speed flight, while providing
mounting points to securely fasten the camera to the quad.
To install the recliner kit, the anti-vibe camera mounting plate must be removed following
these simple steps:
1) Remove both side-plates from the quad.
2) Carefully remove the 4 clips which restrain the pins which run through the rubber
dampers.
3) Remove the plate, mount the GoPro recliner, and attach with the supplied aluminium
screws from the bottom of the plate.
4) Re-install the anti-vibe plate, the pins, and the clips that restrain them.
Lost Model Alarm
The Lost Model Alarm on the Vortex 250 Pro sounds when the quad is disarmed after landing,
or if a receiver failsafe occurs.
The alarm is designed to be as simple as possible, without controls which could allow it to be
accidentally disabled, resulting in a lost quad.
NOTE: The alarm is driven directly from the OSD on the 250 Pro, and not from the Flight
Controller, so changing beeper settings in the Cleanflight configurator will not change its
behavior.
17