IMG STAGE LINE BEAM-4/RGBW, Инструкция по эксплуатации

Страница: 25 / 28

25
Order No. 38.0230
BEAM-4/RGBW
No Response to DMX
Response: Suspect the DMX cable or connectors, a controller malfunction, a light effect DMX card
malfunction.
01)
Check the DMX setting. Make sure that DMX addresses are correct.
02) Check the DMX cable: Unplug the unit; change the DMX cable; then reconnect to electrical power.
Try your DMX control again.
03) Determine whether the controller or light effect is at fault. Does the controller operate properly with
other DMX products? If not, take the controller in for repair. If so, take the DMX cable and the light
effect to a qualified technician.
Problem Probable cause(s) Remedy
One or more
fixtures are
completely dead. No power to the fixture.
●
Check that power is switched on and
cables are plugged in.
Internal fuse blown.
●
Return the device to your IMG Stage Line
dealer
Fixtures reset
correctly, but all
respond erratically
or not at all to the
controller. The controller is not connected.
●
Connect controller.
3-pin XLR Out of the controller does
not match XLR Out of the first fixture
on the link (i.e. signal is reversed).
●
Install a phase reversing cable between
the controller and the first fixture on the
link.
Fixtures reset
correctly, but some
respond erratically
or not at all to the
controller.
Poor data quality
●
Check data quality. If much lower than
100 percent, the problem may be a
bad data link connection, poor quality
or broken cables, missing termination
plug, or a defective fixture disturbing
the link.
Bad data link connection
●
Inspect connections and cables.
Correct poor connections. Repair or
replace damaged cables.
Data link not terminated with 120
Ohm termination plug.
●
Insert termination plug in output jack of
the last fixture on the link.
Incorrect addressing of the fixtures.
●
Check address setting.
One of the fixtures is defective and
disturbs data transmission on the
link.
●
Bypass one fixture at a time until normal
operation is regained: unplug both
connectors and connect them directly
together.
●
Have the defective fixture serviced by a
qualified technician.
3-pin XLR Out on the fixtures does
not match (pins 2 and 3 reversed).
●
Install a phase-reversing cable between
the fixtures or swap pin 2 and 3 in the
fixture, that behaves erratically.
No light or lamp
cuts out
intermittently
Fixture is too hot.
●
Allow fixture to cool.
●
Make sure air vents at control panel
and front lens are not blocked.
●
Turn up the air conditioning .
LEDs damaged
●
Disconnect fixture and return to your
dealer.
The power supply settings do not
match local AC voltage and
frequency.
●
Disconnect fixture. Check settings and
correct if necessary.