IMG STAGE LINE BEAM-4/RGBW, Инструкция по эксплуатации

Страница: 10 / 28

10
Order No. 38.0230
BEAM-4/RGBW
Multiple BEAM-4/RGBW s (Master/Slave control)
Fig. 04
Multiple
BEAM-4/RGBW s (DMX Control)
01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable ( e.g. IMG Stage Line TAR-1004SAVE or TAR-603SAVE ).
03) Use a 3-pin or 5-pin XLR cable to connect the BEAM-4/RGBW s and other devices.
04) Link the units as shown in fig. 05. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX-signal cable. Repeat this process to link the second, third, and fourth units.
05) Supply electric power: Plug electric mains power cords into each unit's IEC socket, then plug the
other end of the mains power cord into proper electric power supply sockets, starting with the first
unit. Do not supply power before the whole system is set up and connected properly.