IMET SIRIO 315, Инструкция пользователя

Страница: 19 / 41

TRADUCTION OF THE ORIGINAL INSTRUCTIONS FOR USE
S315 SH eng ED.2011 rev.00 17/41
- 14 - --- BLADE ASSEMBLING
Choose the blade characteristiques following the indications of the previous tables and procede as follows:
Remove the screw of the upper corner of the transparent part of the coverblade guard and remove it also.
If pneumatic vice is mounted, probably it is necessary turn the machine turntable to the right/left side to allow
the transparent part slide.
Unscrew the screw -pos.1/dr.RI0062 with right thread, remove the parts-pos. 2 and 3/dr.RI0062 and keep that the
support surfaces are clean.Thread the blade-pos.4/dr.RI0062- by guiding the teeth in the rotation direction shown by
the PRINTED ARROW on the coverblade guard and make the blade holes agree with the holes of the fixed flange -
pos. 5/dr.RI0062-.
Reassemble the closing flange -pos.3/dr.RI0062, the spring -pos.2/dr.RI0062 and the screw po-pos.1/dr.RI0062-.
Before tighting the screw, please wheel the blade forward ( in the clockwise sense ) to cancel the being shake
between the driving pin and the holes.
Replace in its place the transparent protective part and fix it bythe upper corner screw.
-15 -- STARTING
The sectionalising devices of the outer energy are :
On the frontal panel there is the main switch with interlocking attachment , that is the emergency device also.
The control panel, placed in front of the operator includes :
1- The main switch with interlocking attachment and overload thermic protection with undervoltage relay -
2- Motor speed selector ; 3 position (1 - 0 -2 .) for two speed motor machine
.
On SEMIAUTOMATIC MODELS the control panel includes also
3- Vice selector opens or closes the vice by pneumatic action
4- Coolant switch
5- Start button
6- Stop button