IMET SIRIO 315, Инструкция пользователя

Страница: 18 / 41

TRADUCTION OF THE ORIGINAL INSTRUCTIONS FOR USE
S315 SH eng ED.2011 rev.00 16/41
Prepare the cooling by mixing the cutting oil and water ( the tank holds about 15 litres ) in proportion of 1/10, 1/15 or
according to the instructions of the supplier of the product.Pour the coolant into the lower plastic tank placed inside the
base; is possible to reach it by front side after taking out lower part -pos.11/dr.RI0324 or by the back side.
If not you can pour it directly between the work table and the base.
In this case keep attention that the removable chip tray and the tank are correctly placed. a
13.2 - PNEUMATIC CONNECTION )
for semiautomatioc models or manual models equipped with pneumatic
vices or minimal lubrication system).
It is right to connect it to a system provided at least with condensate discharger, with pipes correctly setted, at least
with a pressure of 5/6 BAR. The consumption of air is about .5.Nl max. for each semiautomatic cycle.
13.3 -- ELECTRICAL CONNECTION
Verify that the voltage and the power frequency are compatible with numbers reported in the technical data plate ( It is
placed on the right side of the head column) a difference over 10% causes some working unevenness more or less
manifested.
Connect the switch to a suitable socket or replace it with that of normal use( in the case the switch must be
replaced , the work must be done by an electrician ). The phasing performed by the manufacturer allows to get
a rotation of all motors by connecting the wires in the following order L1=R, L2=S, L3=T, anyhow check as
follows
( for semiautomatic model: with compressed air connected, pressure not lower than 2 BAR ).
MANUAL MODELS:
a)if EMERGENCY button is pushed, turn it off and turn it 1/4 of turning in the marked direction.- .
b) turn the motor speed selector to 1- pos.2/dr.RI0324-.
c) close the cock of the coolant circuit-pos. 2 of below picture-.
d) Switch ON the main switch -pos.1/dr.RI0324- and be sure that the spindle turns in the direction shown by the
PRINTED ARROW - on the coverblade guard;
.
SEMIAUTOMATIC MODELS
a) if EMERGENCY button is pushed, turn it off and turn it 1/4 of turning in the marked direction.
b) turn ON the main switch-pos.1/dr.RI0064, the lights flash on the control panel.
c) Switch OFF the coolant
d) turn the lower cutting speed regulator on 0
e) push the white button ( I ) to start the cycle - and be sure that the blade or spindle-turns in the direction shown by the
ARROW ON THE CARTER
–
Take care to the possible downfeed movement of the saw head.
If not, please turn OFF the main switch-pos.1/dr.RI0324-, disconnect the feeding plug, reverse the connection of two of
the line wire, excluding the green/yellow cable of the grounding and start again from point a).
d) be sure that coolant is sucked in by the tank and it arrives in the cutting area ( by opening the cock pos.2 -)
e) stop the machine by turn the main switch off -pos.1/dr.RI0324-.