IMET SIRIO 315, Инструкция пользователя

Страница: 11 / 41

TRADUCTION OF THE ORIGINAL INSTRUCTIONS FOR USE
S315 SH eng ED.2011 rev.00 9/41
Standard adjustable bar stop - fixed on the right side,
it is necessary to make more cuts with the same
lenght.
Voltage transformer - set it between the electric
equipment of the building and the electric supply of the
machine. It allows to work with a different voltage than
the standard one (that is 400V ). Available voltages are
230V, 460V , 500V, 575V.
Minimal lubrication system
–
This device, applied to
the saw, allows to eliminate almost completely the
traditional coolant system, keeps the material much
cleaner and avoids to waste cutting oil and water. It
works only during the cut.
It is comprised of a PIN-nozzle
–as shown by the arrow
- with 3 micro-holes, a tank with devices to adjust the
quantity of oil and the air pressure. The switch of the
electric system - working with low tension 24V AC (or
230 V AC on manual model) allows to turn it off at any
moment and use the normal coolant system.
It works with air supply connection, about 4/6 Bar.
Note :This picture is referred to a SIRIO 370 model
10 - BLADE CHOICE
In this paragraph we suggest the type of blade to use for cutting and the material that must be worked. To get the best
performance from this machine it is necessary to understand the right applications of the used tools and what you have
not to do with them.
The blade you have to use must have the following dimensions (in mm.):
external diameter = 315 max./300 min.
hole dia. 40 ; thickness = from 2 to 3
2 holes for the driving pin = d.11 x 63 or d. 12 x 64
P.S. You can get the maximum cutting sizes by using the blade of maximum diameter.
For making a right cut it is also necessary to establish the pitch ( t ) or the suitable number of teeth ( z ). The
blade must usually have the toothing as follows:
- close toothing (little teeth) for cutting thin materials, tubular and profiles.
- thin toothing (big teeth) for cutting solid materials or pieces that need a long piece of blade (for example the central
part of a “U” profile ), or more soft materials as aluminium, copper, soft bronze.
By choosing the right one you can avoid a lot of working errors and you can get a good blade penetration and the
necessary space for the chips.
If you cut more pieces at the same time, you must consider them as one piece (that is you have to consider
the global size).
The enclosed table shows the necessary information for a right choice.
It can also be updated or changed by the
user according to his personal experiences